Home

GUIDE Measuring & installation

How to measure and install
aluminium louvres.

WORKER makes complete units (frame and blades) to your sizes; WORKER and its dealers install nationwide, or you can fit them yourself or hire a local installer. These short videos show how to measure, choose the right system and fit the louvres properly.

Step-by-step videos

How to measure and fit aluminium louvres (8 steps)Measure width and height, send the sizes, set the unit in the opening, screw, seal and test the blades.
Measuring an out-of-square openingMeasure top and bottom widths, left and right heights, send all four with a photo; shim and seal the gap.
Choosing the right shutter system for each locationMax for large facades, Pro for windows and balconies exposed to rain, Smart on existing aluminium-glass doors, Fixed for vents, skylights and AC screens.
Fitting a large facade with Worker-MaxMeasure the whole facade, split into panels (each seamless up to 3.5 m), set each panel, screw, block the west sun.
Shading a skylight: two ways to fitLay the louvers under the glass roof or stand them at the skylight opening; choose Fixed or Pro; send photos and sizes.
Fitting shutters above a balcony railingMeasure from the railing to the ceiling, split into leaves, set the frames, screw into the ceiling and side walls.

The basic steps

  1. 1Measure the width and height of the opening in mm. If it is out of square, also measure top/bottom and left/right.
  2. 2Send the sizes and a photo to WORKER for a quote and to confirm the production size.
  3. 3Receive the finished unit (frame and blades) made to size.
  4. 4Set the unit into the opening and level it with a spirit level.
  5. 5Screw the frame to the wall: both sides, top and bottom.
  6. 6Seal the gap around the frame with silicone, then test the blades.

Real installation videos

Filmed on real projects to help you or your installer follow each step.

Measuring the opening (width × height)Measuring on site before ordering.
Setting the unit into the openingThe finished unit is set into the opening and aligned.
Screwing the frame to the wallScrews go through the frame at evenly spaced points.
Fixing the frame with screwsFixing the frame firmly before sealing.
Sealing around the frame with siliconeSealing the gap between frame and wall against water.
Sealing, then testing the bladesFinishing the seal and checking the blades tilt smoothly.
Fitting large shutter panels on a balconySeveral shutter panels fitted as one large screen on a balcony.

Frequently asked questions

Does WORKER install the shutters?

Yes. WORKER and its dealers install nationwide at the installed prices shown on the product pages (delivery and installation included, VAT excluded, depending on distance and quantity); send the quantity (number of sets, sizes) and the site address for an exact quote. To install yourself, WORKER delivers complete units (frame and blades) at the factory price that you fit yourself (screws and sealant) or with a local installer; the videos on this page show how to do it properly.

How do I measure correctly?

Measure the width and height of the opening in mm. If it is out of square, also measure top, bottom, left and right and send all the figures with a photo so our technicians can confirm the size.

Can WORKER survey and measure on site?

Yes. WORKER offers on-site surveys and measuring; our staff will quote the survey fee once the project details are known.

How long does delivery take?

Delivery takes 3–7 days depending on timing, nationwide.

Send your sizes for a quote

Nationwide delivery. Factory prices, the same nationwide.

Get a quote by size